Main > Main Forum

spinner question (tempest)

Pages: << < (2/2)

ssc arcade:

thanks again, I will give it a try, it has the mini header plug so I will probably just see if I can trace the wires back to the plug and reverse the wires at the header instead of messing with solder.

Not the prettiest spinner, I may try and post some pics later.  I basically followed the write ups for the HDD based spinners.  One item I found out is that hot glue can be your friend.  I will see if it holds up but it made it much easier to get the mouse wheel rod to the HDD bottom and the mouse body cut in half with PCB attached to bracket.  It will allow you to remove and adjust without much problem.

I included a pic of the top side just for the heck of it.  (yes I went with the quik bunny spinner)

vizzinni:

Nice CP.  My spinner was based on the Cheep Spinner design, so that's the kind of hack I was envisioning in my response...


Pages: << < (2/2)

Go to full version