| Main > Software Forum |
| Need INI files |
| << < (2/3) > >> |
| Minwah:
As I said, the how-to assumes a few things...one of them being that you do NOT want modes with over 256 lines (ie see the bit where I recommend removing those modes). The reason I do this is because on standard arcade monitors your vertical size needs to be adjusted down to fir say 288 lines on. However, this means horizontal games will generally be letterboxed (have borders top/bottom). I do not know if this is the case with your D9200, but since it can store different sizes/positions for different modes probably not. So, here is a modified how to: Run M.A.M.E. Resolution Tool, Ensure the |
| electricd:
OK trying again. One line I don't understand: Remove modes with >256 and <448 lines (these will not fit on your screen), Remove anything with greater than 256 lines and less than 448 lines? Am I reading this wrong? Is one referencing vertical and one referencing horizontal? Thanks in advance! |
| electricd:
Ok, besides the line I didn't understand, I followed your directions to a T, and still got the wrong resolution for Galaga. See screen capture: |
| Minwah:
--- Quote from: electricd on March 09, 2006, 10:19:27 am ---Ok, besides the line I didn't understand, I followed your directions to a T, and still got the wrong resolution for Galaga. See screen capture: --- End quote --- Did you try my 'updated' how to in my last reply? I ask because the line you don't understand is not in it. Edit: also, I cannot see the screen capture very well but it looks like you've removed the 50/51hz modes, which you should also not do based on my modified how-to above. |
| electricd:
Yea I followed the updated one, but I thought it only referred to the 2nd half of the readme. I will startover with only what you posted here. Also, if you save the image and view it at 100% it should show up...looks like the board resized it. |
| Navigation |
| Message Index |
| Next page |
| Previous page |