Main > Main Forum
Anyone have Happs L/R Grip Assemblies??
(1/2) > >>
rbarr110:
http://www.happcontrols.com/joysticks/50250800.htm

I am in the process of laying out a yoke for Star Wars and am considering buying the Happs left and right hand grip assemblies.  However, I would love to save $20 on the order and install my own thumb buttons for a few bucks rather than order the grips with the thumb buttons.

If anyone has installed their own buttons for the thumb, how easy was it and what buttons did you use?

I was thinking the little red Radio Shack push buttons would work well if there is enough room to install them.

Thanks
Kremmit:
I just took a set of these apart and measured- looks like a 1/2" hole, and 3/4" length on the switch body.  You could probably go 1" on the length, just barely, and you could probably enlarge the hole a tiny bit, too.
rbarr110:

--- Quote from: Kremmit on March 08, 2006, 12:42:40 am ---I just took a set of these apart and measured- looks like a 1/2" hole, and 3/4" length on the switch body.  You could probably go 1" on the length, just barely, and you could probably enlarge the hole a tiny bit, too.

--- End quote ---

Do you by chance have a picture?  Or could you possibly take one?


Thanks
Kremmit:
I'll open it up again tonight and get you one.
rbarr110:

--- Quote from: Kremmit on March 09, 2006, 10:56:56 am ---I'll open it up again tonight and get you one.

--- End quote ---

Thanks a ton, doing me a huge favor at no benefit to you.  I owe you one.

THANKS!!
Navigation
Message Index
Next page

Go to full version