| Main > Main Forum |
| JAMMA Test Rig Suggestions? |
| (1/2) > >> |
| Witchboard:
I've got a line on a PSone LCD that should be showing up in the mail this week. I'm wanting to create a self contained JAMMA board tester including a kick harness. I plan on having about 4' of the JAMMA harness outside of the box so I can test boards in cabinets. I've already presumed I'll be needing the Test, Service, Coin and both player Start buttons. Is there any suggestions of something I may have not thought of? I'm not too concerned about including a coin counter, considering I'm not an op, but I'm finalizing the planning stages and was wanting some feedback on something I may have missed. |
| BobA:
An amp meter to see how much current is being used by the 5V supply is useful as is a speaker. Also useful is access to the 5V control and a volt meter to set 5.1V etc for boards that need a bit of boost. |
| Witchboard:
I have a 3" 8ohm shielded speaker that I'm going to install. What would be the usefulness of an amp meter? Not that I'm saying it's not a good idea, I just don't know what pertinent information it would provide. |
| BobA:
The amp meter will show if the board is drawing too much current compared to its rating. This is good info when troubleshooting boards. |
| Witchboard:
Well, I'll be the first to admit that I'm not savvy enough to know what to look at or what could be wrong when it's drawing too many amps. Not to say that I won't learn in the near future. ;D They seem cheap enough on eBay. I'll take a look at my local places and see if they carry them as well. I guess one like this would work? It seems small and affordable. It states it needs a "Shunt" resistor. |
| Navigation |
| Message Index |
| Next page |