Main > Woodworking

Which router bits do I need?

(1/2) > >>

leapinlew:
Hey guys - I am in need of a couple bits. Could someone confirm if these are the bits I need:

1st bit is intended to be used to trim the plexiglass/lexan.
http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_flush.html
If yes - does the cutting length matter between a 1" and a bigger size? The Plexi will probably only be 1/8

2nd bit is inteded to cut the 1/16th in slot for the t-molding
http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_slot.html#Anchor%20slotct3w

My router accepts 1/2" shank.

Thanks, I appreicate the help. I'm very much a rookie with this woodworking.

Fozzy The Bear:
The first one is fine Lew.....  But I can't see a slot cutter on the second list that has a 1/16 cut height.  The right sort of cutter, just not the right thickness of cut.

Personally I use a 16th" biscuit cutter....  They're used for cutting a slot to take a glue in jointing biscuit in furnature making.

Best Regards,
Julian (Fozzy The Bear)

leapinlew:

--- Quote from: Fozzy The Bear on March 02, 2006, 12:28:05 pm ---The first one is fine Lew.....  But I can't see a slot cutter on the second list that has a 1/16 cut height.  The right sort of cutter, just not the right thickness of cut.

Personally I use a 16th" biscuit cutter....  They're used for cutting a slot to take a glue in jointing biscuit in furnature making.

Best Regards,
Julian (Fozzy The Bear)

--- End quote ---

First bit good - thanks.

As for the second bit - I was thinking in the lower table, top right under 1/2" shank is set #7641

?

Fozzy The Bear:
Yup! You're right.... I see it now.... Doh!!!  ::)

Yes, that should do the job.

Best Regards,
Julian (Fozzy The Bear)

leapinlew:
Awesome! Thanks for the help Foz...

order placed

Navigation

[0] Message Index

[#] Next page