| Main > Main Forum |
| Building a star wars yoke...have a question |
| (1/3) > >> |
| rbarr110:
I searched and I believe the last post here tells me exactly what I am thinking, but I want to be sure. http://forum.arcadecontrols.com/index.php?topic=45490.0 I have read through this http://arcadecontrols.com/hosted/yoke/ for info on how to do it, and have been using Autocad to draft up the plans and making a few small changes. Anyway, teh guide says use (2) 40 tooth gears and (2) 20 tooth gears. I am assuming the tooth count isn't important, but that the 2:1 ratio is what is needed. |
| Havok:
2:1 ratio should do fine. Make sure to post your project, I attempted to make one of these and gave up for a while: I can't cut wood worth crap. At least I have all the parts to make it when I finally get around to trying again. Must practice more with the scroll saw... |
| NoOne=NBA=:
--- Quote from: Havok on March 02, 2006, 12:34:04 am ---Must practice more with the scroll saw... --- End quote --- Forget the scroll saw. Draw your target line, rough cut the wood with a circular saw, and then sand it down to the line with either a belt sander, or a sanding attachment for your drill. I usually end up having to come behind my jigsaw/bandsaw/scrollsaw with a sander anyway, due to blade deflection. |
| rbarr110:
OK |
| Kremmit:
I don't think there's 90 degrees of travel forward and back the originals. There was a thread once where somebody measured it, but I'll be darned if I can remember where it is. Anyone? |
| Navigation |
| Message Index |
| Next page |