| Main > Software Forum |
| problem with Fraggal boot cd |
| (1/2) > >> |
| POS:
It seems to load fine but will not boot after restart. It goes to an X: prompt and when I cd to c: and EXE arcadeos it wants to boot from the CD ROM drive. I know this is an older version and it seems to work with my arcade monitor, does somone recomend a newer better set up compaq 500 ATI Rage Pro (pc running ) |
| JoyMonkey:
It should only boot to an X: prompt if you still have the CD in the drive. Take the CD out and reboot. |
| POS:
I have tried but says Abort, Retry, Fail. It shows a c: but everytime I acess it wants to pull from the CD. |
| JoyMonkey:
--- Quote from: POS on February 27, 2006, 02:16:59 pm ---I have tried but says Abort, Retry, Fail. It shows a c: but everytime I acess it wants to pull from the CD. --- End quote --- During the CDs install procedure, are you sure you created a primary DOS partition and formatted it fully? |
| POS:
yes it did format. using the format procedure that comes with the cd. I used three different drives 1. drive had a linux program on it i used Fragg's disk deleted non DOS part. formated and installed the programs. when I rebooted it went to a Grep prompt. 2. disk didn't work at all wouldn't format 3.disk is the one that i'm currently fighting. do you have any recomendation on another setup. I just want somthing that will run with my arcade monitor and ArcadeOS runs well with my onboard Video ( ati rage pro) |
| Navigation |
| Message Index |
| Next page |