Main > Project Arcade - the book!

Mounting Back Angle Section.. Please help

(1/1)

AMDman13:
The section describes drawing a line 3/4 from cabinet edge parallel to the angled sections. Then flush the top of the mounting strips to this line.

My question is shouldn't it be 1&1/2 inch so that when you lay the 3/4 panel in place and it will still be recessed 3/4??

Sorry to be so confusing! I guess what I'm asking is flush or recessed???

Any help would be greatly appreciated!

Thanks!

saint:
Well, you're right. As instructed, that leaves the panel flush with the edges of the cabinet, not recessed 3/4".  I have the back angled section recessed 3/4" ...

* saint adds it to the typo list.
Good catch!

AMDman13:
Thank you Saint! I stayed up scratching my head over this one :)...(NOt the first time) I test fitted the angled section with the top back panel and it looks like everything is going to go together sweet!  :)

RTSDaddy2:
I knew something was wrong, but assumed it to be another line that I measured incorrectly.  Mine wound up flush to the back of the cabinet...but as it's on the back, I wasn't going to rip it apart to start over again (had gone too far by that point...support pieces glued in, etc).

Still, though - looks good...and definitely impresses the people who see it!

Navigation

[0] Message Index