Main > Main Forum

New Product: TurboTwist

Pages: << < (19/38) > >>

RandyT:


--- Quote from: Witchboard on February 27, 2006, 10:53:23 am ---Here's a question.  Will the encoder wheels by themselves be available for purchase?  I didn't read all the technical stuff so I'm not sure if the high resolution benefit is reliant on both the encoder wheel and the optic board, or just the wheel.  If it's just the wheel, it would be nice to upgrade my existing spinner.

--- End quote ---

All components of the TurboTwist

markrvp:

1up did the up/down hack:

Kremmit:

Mark's Pic-Fu is weak.

screaming:


--- Quote from: markrvp on February 27, 2006, 11:51:23 am ---1up did the up/down hack:

--- End quote ---

  Yes yes. that's who it was. I had it saved somewhere in my grand pile o' links..

  Anyway, I wonder how hackable the GGG spinner is? I'm hoping to at least get "push" functionality. Anyone who has a GGG spinner willing to comment on the possibility after taking a look at 1up's great work?



Xiaou2:


 wow,  i didnt expect that the encoder wheel was (laser?)  printed.

 However... the question is... How it the encoder wheel centered?

 Are you having them laser cut?   As if the center hole is off by just a tiny bit,  it may greatly mess up the tracking from the resulting wobble motion.   

 Also, if someone were to loosen the screw..  and then re-tighten it... would the allignment still be perfect?   Meaning...  Is there any  'play'   between  the
encoder hole  and  the screw shaft?   



Pages: << < (19/38) > >>

Go to full version