Main > Main Forum

New Product: TurboTwist

Pages: << < (4/38) > >>

Mario:

What's the height of the shaft? i.e., can it be used with a 3/4" thick wood panel without needing to reduce the panel thickness? It would be cool if it has a shaft that is adjustable in length to support panels of various thicknesses.

Mario

Fozzy The Bear:

WOHHHHHHH!!!!!!!  :o  ;D ;D ;D

That is just damned brilliant!!!  ;D  Randy does it again! Providing the community with something spectacular at a very reasonable price. So Cool.

It's on my wants list..... now how can I convince my other half to let me buy one :-\ I need to find a reason why it's essential to our existance... Tricky!

Randy!! How much is the shipping to the UK on one of these beauties!!

Best Regards,
Julian (Fozzy The Bear)

AllisterFiend:


--- Quote from: Mario on February 19, 2006, 10:00:05 pm ---What's the height of the shaft? i.e., can it be used with a 3/4" thick wood panel without needing to reduce the panel thickness? It would be cool if it has a shaft that is adjustable in length to support panels of various thicknesses.

Mario

--- End quote ---

Here is what Randy says...


--- Quote from: RandyT on February 19, 2006, 03:59:21 pm ---

* Adjustable Height.  Can be used on everything from metal panels up to 3/4" wood with overlays.  Just loosen the set screw, pull the shaft to the desired length and re-tighten.

--- End quote ---


Allister Fiend

RandyT:


--- Quote from: timoe on February 19, 2006, 09:08:48 pm ---Can the knob be replaced with a knob that takes a traditional 1/4" shaft?

--- End quote ---

The shaft will accept a standard 1/4" knob.

I will be looking at other knob styles in the future but these will be available as a separate item.

RandyT

Xiaou2:


 Sounds good.    Good sturdy design.   Price not bad.    Nice spinner knob.

 How does it have such high resolution?  Do you use dual optics?  Very high teeth count on the encoder?  Dual teeth setup?  Dual encoder wheels?



 

Pages: << < (4/38) > >>

Go to full version