Main > Main Forum
I-Pac Programming (Problem Fixed!)
<< < (2/3) > >>
Tiger-Heli:
The older I-PAC needs THIS software: http://www.ultimarc.com/winipac.html (Sounds like thats what you are using, though).

eccs19:

--- Quote from: Tiger-Heli on February 16, 2006, 11:28:35 am ---The older I-PAC needs THIS software: http://www.ultimarc.com/winipac.html (Sounds like thats what you are using, though).



--- End quote ---

Yup, that's the one I'm using.  Bummer if I can't get the programing part of it to work.
eccs19:
Just in case anyone has this same problem,  it turned out that my IPac was not as old as I thought it was.  I just needed the newer software, and away I went.  I had to do a factory reset first, but once that was done, I was good to go.
Tiger-Heli:
Or it may have been old but had the chip upgraded.  Andy sells a chip replacement for the older boards.  I guess the best advice for new users is to try all the software versions.

Glad you have it working!
Mark70:
I was having ipac problems.  My shift function wouldn't work.  Turned out that I bent one of the quick connects and had a button shorting to ground.  That was  hard to find.  I couldn't figure out what was wrong with the ipac.... turns out it was my fault.
Navigation
Message Index
Next page
Previous page

Go to full version