Main > Main Forum

Mini-Pac

Pages: << < (2/4) > >>

ojelela:

Checked main plug there is no shorts, no jumpers to set, but my board flashes 6 times on power up even without harness being plugged in.........

ojelela:

Anyone........????

Thanks

cholin:

Well, Id give Andy a shout in that case because it sounds to me like you have a shorted input somehow.  When the LED flashes several times it means there's an error:


--- Quote ---If inputs test fails: LED flashes a number of times to indicate which switch is shorted or faulty. LED then stays off.
--- End quote ---


ojelela:

Ok, I tested board for voltage and I don't have +5V on pin 3 & 4
it's 2 SW 7 & 2 SW8 every other pin switch I have +5v it seems
like they are puled down permanently.

Just wandering if I can jumper +5v from some other pins that
are not used to pin 3 & 4??? :angel:

mlcampbe:

This may be totally off base but I saw the same problem with scrolling in mamewah before I even had a minipac installed.

I was using a regular PC joystick and if I unplugged the usb cable the next time I plugged it back in I had to calibrate the joystick to keep it from scrolling like you said.

Any chance you have some other device that might need to be calibrated??

Pages: << < (2/4) > >>

Go to full version