| Main > Main Forum |
| Mini-Pac |
| << < (2/4) > >> |
| ojelela:
Checked main plug there is no shorts, no jumpers to set, but my board flashes 6 times on power up even without harness being plugged in......... |
| ojelela:
Anyone........???? Thanks |
| cholin:
Well, Id give Andy a shout in that case because it sounds to me like you have a shorted input somehow. When the LED flashes several times it means there's an error: --- Quote ---If inputs test fails: LED flashes a number of times to indicate which switch is shorted or faulty. LED then stays off. --- End quote --- |
| ojelela:
Ok, I tested board for voltage and I don't have +5V on pin 3 & 4 it's 2 SW 7 & 2 SW8 every other pin switch I have +5v it seems like they are puled down permanently. Just wandering if I can jumper +5v from some other pins that are not used to pin 3 & 4??? :angel: |
| mlcampbe:
This may be totally off base but I saw the same problem with scrolling in mamewah before I even had a minipac installed. I was using a regular PC joystick and if I unplugged the usb cable the next time I plugged it back in I had to calibrate the joystick to keep it from scrolling like you said. Any chance you have some other device that might need to be calibrated?? |
| Navigation |
| Message Index |
| Next page |
| Previous page |