Main > Main Forum

Leafswitches - Check this out!!!!!!!!

Pages: << < (12/29) > >>

Farmboy90:

Do we replace just our microswitches with this?  Or is this for the leaf switch AND the button?  Meaning the button isn't identical to a microswitch button...

Santoro:

Yes, you just replace your microswitch. It will work with existing horizontal pushbuttons.

RandyT:


--- Quote from: JoyMonkey on February 02, 2006, 12:39:03 pm ---I don't think it would work with the RGB-Drive either.
Unless you took a knife to the top of the fixture (where the RGB-Drive gets installed) here...

--- End quote ---

It looks like there is a support structure under there.  Removing it might be bad/difficult.

Looks like these were made specifically for the button, rather than a generic micro replacement.  Which means, they probably wouldn't work for joys either.

RandyT



mahuti:

Heck, when they come in, I'll buy and test. Since I already have my RGB-drive buttons in, shouldn't be to painful.

Santoro:

Pure speculation here, but with the 'pins' portruding through the leaf gizmo, if those horizontal bits are supports they probably aren't bearing a lot of 'load.'  You might be able to get away without one side.


--- Quote from: RandyT on February 02, 2006, 12:47:30 pm ---
--- Quote from: JoyMonkey on February 02, 2006, 12:39:03 pm ---I don't think it would work with the RGB-Drive either.
Unless you took a knife to the top of the fixture (where the RGB-Drive gets installed) here...

--- End quote ---

It looks like there is a support structure under there.  Removing it might be bad/difficult.

Looks like these were made specifically for the button, rather than a generic micro replacement.  Which means, they probably wouldn't work for joys either.

RandyT



--- End quote ---


Pages: << < (12/29) > >>

Go to full version