Main > Main Forum
Minipac/Keywiz/GP-Wiz "breakout" terminal strip board.... interest?
<< < (3/12) > >>
cholin:
Okay, make that about 10 boards so far, since I want more than one and you want 3.

Thanks for helpin me out, builds my confidence :P  LOL  :)
Mario:
The Minipac has two input connectors, one for the digital controls and one for the analog controls (I think that's how they're divided). Are you planning to support ALL of the inputs, or just the digital inputs?



Mario
cholin:
The iPac has two headers.  The small one only provides power and ground points for your trackball.  The large header provides all buttons and trackball and spinner inputs.  I will be supporting the large header only, which will allow you to connect all your buttons, your mouse clicks, your trackball, and your spinner.  Getting power from the iPac is a different story, but its much simpler since its only a 10 pin header and only like 5 pins are actually used, so you can use any old QD and attach it to two prongs... simple.
Tiger-Heli:
The new board would also support the KeyWiz Eco2 non-solder, GP-Wiz non-solder, GP-Wiz40 non-solder (as well as the MK40 and MK64's, and Hagstrom encoders).
cholin:
Good point, intended for minpacs though.  Use it as you will.
Navigation
Message Index
Next page
Previous page

Go to full version