| Main > Main Forum |
| Enlarging a hole in a metal CP? |
| << < (2/2) |
| javeryh:
I used the 3/8" metal cutting drill bit and it went through like butter. I had to file down the edges a bit though because it left them a little raised and I need a flat surface. I think I can finally finish my last CP this week! |
| PetitMorte:
For something like this, I would use a T-Reamer. This particular tool is designed for making holes larger, and can be used on a wide variety of materials. It's very precise, and easy to use. In putting together my cab, I found many uses for it. |
| Navigation |
| Message Index |
| Previous page |