Main > Main Forum
Attaching CPO suggestions?
(1/3) > >>
namedos:
I am anxiously waiting for my CPO to be printed by Mamemarquees.  I will be attaching it to a new Control Panel and I was wondering if anyone had any suggestions or advice on the best way to do this.

Thanks!
Bones:
Are you using Lexan?

Many times the Lexan held in place by the buttons is enough to hold it all down.

If not, you may have to consider some type of spray-on adhesive.
namedos:
No lexan, Mamemarquees is using that thick material that protects the CPO.

I'm planning on using a spray on adhesive although I do have some concerns that the front edge will peel up.
namedos:
>>bump<<

Has anyone bought a CPO from Mamemarquees?
markrvp:
Are they not printed on adhesive vinyl?  If they are, then you just peel off the protective backing and stick it down.  If not, then get 3M adhesive vinyl from Home Depot.

Here is the tip of the day(if it is adhesive vinyl) - spray a fine mist of water on your CP before putting down the adhesive vinyl.  This will keep it from sticking hard right away and allow you to move it a little bit once it's down.  Once you get it positioned just right, use a roller to roll out the moisture.  Wipe the whole thing off with a paper towel and you get a perfect application.
Navigation
Message Index
Next page

Go to full version