| Main > Main Forum |
| New Product: Opti-Wiz |
| << < (5/23) > >> |
| daywane:
3 axis? mouse = x and z x = (east and west) z= (north and south) y= up and down? like a button? I am confused I work with mill lathes at work x - will make the part smaller in diam. x+ larger in diam z- shorter in length z+ longer in length I have no Y ( I assume "Y" is up and down) I just do not get it. I must be over thinking this |
| SirPoonga:
Z is used for the scroll wheel. |
| RandyT:
--- Quote from: Tiger-Heli on January 03, 2006, 06:36:26 am --- --- Quote from: PoDunkMoFo on January 01, 2006, 04:31:06 am ---Would you need analog mame to make this work? --- End quote --- You will need either XP or Analog Mame to enable two mice controlling separate players, otherwise, no standard MAME will work. (Two-player CABAL, Marble Madness, etc. needs Analog Plus or XP). --- End quote --- But not if you are using the axes individually for each controller (say 1 trackball and 1 spinner) or ? RandyT |
| markrvp:
--- Quote from: daywane on January 03, 2006, 10:02:15 am ---3 axis? mouse = x and z x = --- End quote --- |
| Havok:
--- Quote from: RandyT on January 03, 2006, 10:24:45 am --- --- Quote from: Tiger-Heli on January 03, 2006, 06:36:26 am --- --- Quote from: PoDunkMoFo on January 01, 2006, 04:31:06 am ---Would you need analog mame to make this work? --- End quote --- You will need either XP or Analog Mame to enable two mice controlling separate players, otherwise, no standard MAME will work. --- End quote --- --- End quote --- |
| Navigation |
| Message Index |
| Next page |
| Previous page |