Main > Main Forum
WTBorrow 3.25" Hole Saw
<< < (3/3)
LPZ:
I tried a 3", but the hole did not accomodate the black case that the ball is in.  I measured with a micrometer, and it comes out to 3.25 to accomodate it.

quarterback:

--- Quote from: LPZ on December 29, 2005, 05:06:47 pm ---Thanks for all the help fellas. 

Quarterback--Checked the local harbor frieght.  Every size except 3 1/4.
--- End quote ---

Sorry, when I said "something like that", I was actually referring to the post that I quoted with the ASCII drawing of a resizable hole cutter.   My HF had a couple of them.  I'll take a pic of the one I bought.
quarterback:
Here's a pic.  Like I said, my HF had a couple different ones.  In my first post I said I got the one with three cutters, but that's incorrect.  I got the one with two cutting blades because mine will cut holes from 1" to 5" in diameter.  The three-bladed one wouldn't do up to 5" and I needed to cut a 4"+ hole.  The one with three blades was actually 'better' because all three blades would extend from a center disc at the same time.   I couldn't find either one on line, but at my HF they were over near all the drill bits and stuff.

Anyway, here's the pic.
Navigation
Message Index
Previous page

Go to full version