| Main > Main Forum |
| potentiometer centering when swapping? |
| (1/2) > >> |
| Matthew Fisher:
I have a Happ's analog stick and I swapped the 5K pots for 100k and wired it up to go to the gameport. The darn thing just won't calibrate correctly, however. Symptoms: (best explained by behavior in Star Wars) no matter what I do, when the stick is at rest, the cursor sits about 2/3 of the way up the screen and I cannot get it to aim at anything in the bottom third of the screen. I have tried calibrating in MAME and using JCENTER, an old CH utility that came with their flight yokes. My question is (before I take this thing apart), how important is it to physically center the pots when swapping? I guess I assumed this would all be worked out in calibration, so I wasn't too careful to center the pots when I swapped them. Was I wrong? Thanks in advance. |
| Kremmit:
Have you calibrated through the Windows Control Panel? If that doesn't work, then it's probably time to center those pots. |
| Matthew Fisher:
Sorry, forgot to mention, I am running in DOS. I guess I will take it apart (again :() to center the pots. |
| u_rebelscum:
--- Quote from: Matthew Fisher on December 28, 2005, 07:11:32 am ---Sorry, forgot to mention, I am running in DOS. I guess I will take it apart (again :() to center the pots. --- End quote --- Yes, DOS is a pain to center, even with good drivers. (Windows98 on come with "good drivers", AFA centering goes.) Check what type of "taper" your new POT has: * you should NOT use "audio", the resistance is logarithmic * "S-curve", like happs, has a "dead spot" in the middle, and thus needs to be centered, good driver or not * "linear", with a good driver shouldn't have to be centered, but it you don't have that driver, you'll have to center it. |
| Matthew Fisher:
Ah, I forgot about the s-taper! I have the Happs, so I will just pull out the trusty multimeter and get those things centered, like I should have done when I put them in... :-[ |
| Navigation |
| Message Index |
| Next page |