Main > Main Forum

How to fix major slowdown caused by controls

Pages: << < (2/2)

2600:

Are you interested in doing a bit more testing to try to isolate the problem even more?  Other people have this problem and it would be nice to isolate it a bit.  If your busy, don't worry about it.


If so, here are some questions:
1. Can you describe your PC a little?  Basically, want to know what chipset.
2. Does the OS have all available updates? What OS?
3. What drivers do you have installed?
4. What was the brand and model # of the hub?  If your really want to get down to it, open up the hub and what is the writing on the chip inside it.

dema:

1. My PC is a HP I bought online and I got it with an Intel P4 3.2 Ghz processor.

2. My OS is a little behind in the upgrading process. I haven't upgraded it since early 2005. Once I had it working I kept it as it was in order to preserve the work and the settings I chose. Then when I upgraded the Mame and Mamewah versions I realized I probably shouldn't have wasted the time preserving a working version and instead just taken care of everything when I was finished.

3. I'm not sure which drivers you are referring to. For the encoders I didn't need to install any drivers since they were programmed to be recognized by the computer automatically upon plugging in the USB.

4. I used the Targus 7 port 2.0 USB hub, model number PAUH212. When I swapped out the hubs I realized that it also caused a problem for me on startup, where if it was plugged in the OS wouldn't boot. I had to boot up without the USB from the hub plugged in, and then attach it once the XP was running.



Pages: << < (2/2)

Go to full version