Main > Software Forum
what fornt end and emulators to use?
<< < (3/5) > >>
mrynit:
i ment to say Atomic FE. what i want is MAME, ZSNES and some nes emulator all to work with a front end that uses only jpystick and a few buttons, no keyboard interface after it has been set up. so my question to you(all) what front end do i use to run the above stated emulators? i hear MameWah will run any emulator. but will MAME32 run the above stated emulators?

sorry for getting off the subject of this post.
youki:
AtomicFE can work only with a joystick and few button. No need keyboard interface.

Anyway, even if a Front End need a keyboard interface and you don't want use it, you can use something like JoyToKey.  This driver will convert joystick input to keyboard input.

I don't  think that in MAME32 you can use "external" emulator. It is only the build'in Mame.

mrynit:
just to clarify, mame32 is a FE and an emulator, which only runs arcade roms
Tiger-Heli:

--- Quote from: mrynit on December 20, 2005, 04:18:32 pm ---just to clarify, mame32 is a FE and an emulator, which only runs arcade roms

--- End quote ---
To be technical - MAME32 is the Windows MAME port with a built-in GUI, which only runs arcade roms.

Based on your other posts, you want an older version 0.55 or so of Command-line MAME, ZSNES, Ultra FCE, and Atomic FE to launch any of them.
Tiger-Heli:
Also - you do NOT need to upgrade hardware.

I played older MAME games on a Pentium 200MMX for many years.
Navigation
Message Index
Next page
Previous page

Go to full version