Main > Main Forum
Grrr... I am still a suckass solderer
<< < (12/17) > >>
ChadTower:

Last night the iron heated up for a good 10 minutes while I was doing something else... I wonder if my irons just take a LONG time to get BACK to full heat after I've used it and wiped it with the sponge.
MaximRecoil:

--- Quote from: RayB on December 14, 2005, 12:43:29 pm ---
--- Quote from: ChadTower on December 14, 2005, 12:13:24 pm ---The thing that gets me at this point is that you had that iron on the wire for only a couple of seconds... I could do it that way for 15 and not get the solder melted.
--- End quote ---

--- End quote ---
ChadTower:

How long would one expect the average $35 station iron, at 40w, to heat back up properly after a use?

Use -> wipe -> put back in cylinder

Would it take a minute?  5 minutes?
MaximRecoil:

--- Quote from: ChadTower on December 14, 2005, 01:22:25 pm ---
How long would one expect the average $35 station iron, at 40w, to heat back up properly after a use?

Use -> wipe -> put back in cylinder

Would it take a minute?
--- End quote ---
ChadTower:

The solder I used last night is brand new, purchased from Radio Shack over the weekend.

The station itself was purchased from MCM about a year ago but only used maybe 5 times since.
Navigation
Message Index
Next page
Previous page

Go to full version