| Main > Main Forum |
| Drilling holes in laminate |
| (1/1) |
| JonnyBoy:
Okay, well, the project is slowly coming together and I have a few odds and ends to take care of. First, I need to drill a few holes into my CP, ones that are too small to drill, laminate, and then route out. I was told to use a hole saw on low speed...is that the way to go? Basically I need to drill my two pinball button holes and my holes for the power switch. Thanks Jon |
| KrawDaddy:
Hey Sandwich the laminate between a wood backing and clamp tightly. |
| JonnyBoy:
So, drill through the wood into the laminate from the back? That's a good idea. Thanks! |
| Navigation |
| Message Index |