Main > Project Announcements
My Pacman profile cabinet (finished!......99%)
whatzcrackn:
Hey, where did you get the cp printed? what kinda of material is it?
c64rulez:
--- Quote from: whatzcrackn on January 20, 2006, 10:49:26 am ---Hey, where did you get the cp printed? what kinda of material is it?
--- End quote ---
I can check what material it is (cause frankly I don't know), and as for the "where" part, well I don't think it would matter since it was printed locally, which means Israel (which probably means it doesn't matter) ;D
whatzcrackn:
lol, I was just wondering If I could get in the usa at the same place. oops? :-\
ChadTower:
Okay, I had lagged on following this project... hella good job, bro.
c64rulez:
--- Quote from: whatzcrackn on January 20, 2006, 11:11:28 am ---lol, I was just wondering If I could get in the usa at the same place. oops? :-\
--- End quote ---
It certainly is going to be OOPS if you'll not be able to ;)
The availability issue for a usa-remote-user in this kind of project is a pain in the butt
The material, however, feels very much like photo paper.
--- Quote from: ChadTower on January 20, 2006, 11:44:05 am ---
Okay, I had lagged on following this project... hella good job, bro.
--- End quote ---
As long as I don't lag on it ;)
Thanks
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version