Main > Main Forum
I just bought a MKII for $400 did I get a good deal
<< < (3/4) > >>
F1are:
i payed $450 for SFII 'CE, which is twice as much as they were sold for more than 10 years ago.
SirPeale:
Remove the JAMMA connector and clean the PCB edge connector with either a pink eraser or a fiberglass pen.  Also push down on all socketed chips.  Then check the voltage @ the JAMMA harness (without the board plugged in, of course).  Hopefully it should be ~5.18VDC.  If it's higher or lower, adjust as necessary.  Then plug it back in and remeasure at the board.
srabelpawz:
  i might be selling MK2, Ultimate MK3 and MK4 (all boards working 100%) as a package deal if the price is right.
testicle187:
Will a jamma connector from MK2 hook right into an MK3 or 4 and be up and running?  Well, except for the lack of a run button.  I might be interested in your setup if the price isnt too high.
srabelpawz:
  you would need to add the run button as MK2 did not have that one. make me an offer on the boards if interested.
Navigation
Message Index
Next page
Previous page

Go to full version