Main > Main Forum
Euro-Stik Mounting?
Fusion Disaster:
Knievel,
I didn't realize these were the sticks you had in your CP. The pic you have posted here, helps to see how you have it mounted. So did you just route out a hole deep enough for the outer edge of the joystick? Or did you cut the hole clean through and then attach brackets to the bottom side to keep it in place?
Any chance you could take a detailed pic of the underside of the joystick?
Thanks!
Brian.
Fusion Disaster:
Also what size MDF did you use for your CP? Is that 3/4" or ??
Knievel:
I always use 3/4" MDF. You'll definitely want 3/4" for those sticks, you have to remove a fair amount of material to get them flush with the CP top.
I'll try and take a pic from underneath for you.
Fusion Disaster:
I ended up using two pieces of 1/2" MDF instead of one piece of 3/4". I cut the top piece the full size of the joystick base and then cut the bottom to only allow the center section through. I then used a few washers as spacers. This seems to work out perfect for mounting. A little more work, but it's turning out nice. Thanks for your help!