Main > Main Forum
T-Molding groove too wide!! Help please
(1/3) > >>
Jeehemdee:
Hi,

The T-Molding groove of a cabinet is too wide (possibly due to the the fact that T-Molding was removed and replaced many times)
Now, when I try to place a new one it doesn't stay in place.

What would you do to correct this problem?
Thanks for any kind help ;-)
steptoe:
just  glue it, put tape on as you go to hold it. job done
missioncontrol:
yep I agree use glue
Rocky:
I had that problem with the slot on my Control panel.
ArcadEd:
Take some duct tape, yeah I know haha :P, and stick it to the t-molding itself along the part that goes into the wood.  This will help widen it enough that it will fit it tight, but you can still removed it later if you have too.
Navigation
Message Index
Next page

Go to full version