Main > Main Forum

slot cutter bit 3/32

Pages: (1/2) > >>

Nataq:

This is what I need for a 3/4 t-molding bought at tmolding.com ?

http://cgi.ebay.ca/1-pc-1-4-SH-Slot-Assembly-Router-Bit-4-Cutters-Set_W0QQitemZ6007418840QQcategoryZ50386QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

specifically the 3/32 bit showing there...

wanna make sure...

whammoed:

I use 1/16 for 3/4" tmolding but 3/32 would probably work as well.  I'm sure someone else will chime in with confirmation.

Lilwolf:

Is that the size that some people where having troubles keeping the tmolding to stay without gluing?

Ldsfunaz:

I think so, I don't see why you would need to go bigger than 1/16" because that seems to be perfect for my t-moulding.com order.

-LDS-

tray262:

I would stick to the 1/16". If you are buying this because it is cheaper, I'd suggest taking a roll of doulbe sided tape (3/4" wide roll, and not the foam stuff just the thin stuff) and taping over the slot then pushing yout tee molding in, it will make a tighter fit plus it adds adhesive. just my $.02.

Good luck.

Pages: (1/2) > >>

Go to full version