| Main > Main Forum |
| slot cutter bit 3/32 |
| (1/2) > >> |
| Nataq:
This is what I need for a 3/4 t-molding bought at tmolding.com ? http://cgi.ebay.ca/1-pc-1-4-SH-Slot-Assembly-Router-Bit-4-Cutters-Set_W0QQitemZ6007418840QQcategoryZ50386QQssPageNameZWDVWQQrdZ1QQcmdZViewItem specifically the 3/32 bit showing there... wanna make sure... |
| whammoed:
I use 1/16 for 3/4" tmolding but 3/32 would probably work as well. I'm sure someone else will chime in with confirmation. |
| Lilwolf:
Is that the size that some people where having troubles keeping the tmolding to stay without gluing? |
| Ldsfunaz:
I think so, I don't see why you would need to go bigger than 1/16" because that seems to be perfect for my t-moulding.com order. -LDS- |
| tray262:
I would stick to the 1/16". If you are buying this because it is cheaper, I'd suggest taking a roll of doulbe sided tape (3/4" wide roll, and not the foam stuff just the thin stuff) and taping over the slot then pushing yout tee molding in, it will make a tighter fit plus it adds adhesive. just my $.02. Good luck. |
| Navigation |
| Message Index |
| Next page |