Main > Main Forum
Hooking up a coin mechanism
<< < (6/10) > >>
SirPeale:
1) are those "white things" near the coin door?

2) can we get a picture of them?
mag48:
on the end of the wires in the one picture i showed comming out of the coin door u can see a little cap on the end of the wires... are they supposed to stay like that?? or do i pull that cap off?
CheffoJeffo:
Peale -- I think that this machine at one point had a coin door harness, but it is no longer there.

My advice to mag48 was to trace each wire backto the board and note the pin number (I provided him with a copy of the manual and pinouts).

Cheers.
SirPeale:

--- Quote from: CheffoJeffo on October 02, 2005, 07:50:21 pm ---
My advice to mag48 was to trace each wire backto the board and note the pin number (I provided him with a copy of the manual and pinouts).


--- End quote ---

Ah, now I see.  That's exactly what he's going to have to do.  Get in there with a flashlight and find the answer for yourself.  Since we're not in front of the cabinet, we can't do it for you.

And no, don't pull that connector off.
SirPeale:
Also, since the wires are likely color-coded, you can likely just look on the connector on the main board to see which wires are for coin.
Navigation
Message Index
Next page
Previous page

Go to full version