| Main > Main Forum |
| Hooking up a coin mechanism |
| << < (4/10) > >> |
| CheffoJeffo:
--- Quote from: mag48 on September 30, 2005, 06:05:16 pm ---ALL the wires that make the game function are there.... just not the wires to the coin mechanism to the main power supply or whever i connect it --- End quote --- On the harness, is there a wire at pin 18? 18 is on the parts side of the board (e.g. not the side that only has solder on it). 8 is where the key (e.g. gap) is. There are 2 sets of 28 pins (1 for each side of the board). Cheers. |
| mag48:
umm let me check i just found thist giant block of wires in the back... |
| CheffoJeffo:
OK ... now the fun :-[ part ... you need to trace these wires back to the PCB and make note of which pin they connect to (should be a number between 1 and 28 / parts side or solder side). From that, we should be able to tell which wire to connect where ... and that's 95% or the battle. Cheers. |
| CheffoJeffo:
Bump to see how it went with the folks in the chat room last night ... |
| mag48:
ok... lol i really need a picture by picture step by step thing to show me how to do this lol |
| Navigation |
| Message Index |
| Next page |
| Previous page |