| Main > Main Forum |
| slot cutter bit for t-molding |
| (1/1) |
| Nataq:
Wich ones of these would be the good one for cutting the t-molding groove ? http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_slot.html the 3-wing 1/16 is what I need ? |
| RetroACTIVE:
Depends upon how wide your t-molding is... 1/16" is the correct cutter for 3/4" or smaller t-molding and 5/64" is the correct cutter for 13/16" or wider t-molding... following www.tmolding.com recommendations. |
| Nataq:
I need 1/16. Im just wondering if this 1/16 bit on this page is really what I need :) |
| RetroACTIVE:
yup... just be sure to buy the whole thing if you don't already have a shank and bearing. |
| Nataq:
thanks :) |
| Navigation |
| Message Index |