Main > Woodworking
No table saw? Build a $15 Sawboard for your small budget project!
Rick:
On lunch yesterday, I went to Home Depot, and purchased some 48" x 24" x 1/4" hardboard, and a piece of 48" x 3" x 3/4" MDF commonly used for trim. (It was pre-finished and pre-primed and dead straight.) I had them use their panel cutter (which has always given me perfect cuts) and cut the hardboard down so that I had a piece that was 48" x 12" and two pieces that were 24" x 12". I had them cut the same lengths from the MDF trim. I went home, grabbed my glue and clamps, measured it out and set it up. To that end, I had two sawboards built and ready by the time I returned home. They cost me a grand total of $6.06, including the labour of the HD guy who cut 'em up.
;D
I do have a question on an idea I had. If I'm using this for both my circular saw and my router, why not this idea:
On the side that you'd normally use your circular saw on, I believe there is a 4" - 5" distance between the blade and the edge that the base will ride along. Considering my router base has a 3" distance from the outer guide to centre, if I only use the sawboard with my router using the 1/2" bit (for example), could I cut the channel you see in the diagram above, so that I would use the main side of the sawboard, without compromizing the outer edge? Considering the outer edge (where the circular saw blade would run along) is not under any real strain, I don't see where it would be too much of an issue. I'm just wondering if anyone has tried something like this before? I like the idea, as then, you would have the ability to use either side for your sawboard - the smaller for clamping, or the smaller side of the saw.
Of course, given the inexpensive nature of the build, one of two things is true - either I try it, and if it doesn't work, I rebuild more for a cheap price, or else I just go out and buy more wood to make dedicated routerboards.
Thoughts?
CREDO:
I made myself a few of these sawboards at different lengths the other day. Soo bloody handy. I was using a long straight piece of pine before, and it would get cuts pretty close. Now with a proper guide, i swear its cutting the pencil line in half.
handyest thing ever.
Woodshop Flunky:
--- Quote from: CREDO on October 18, 2011, 12:33:38 am ---...
handyest thing ever.
--- End quote ---
+1
Of all the shop aids I've built, this one has been the best and most enduring.
Namco:
In this Kreg video, the presenter inadvertently rips off our sawboard idea: http://youtu.be/jYdCv5R786c?t=1m38s ... or maybe it was on purpose? :angry:
Anyway, good video on how to use a sawboard.
kalars123:
Just wanted to say thank you for this has helped me in my new builds since I no longer have access to a tablesaw
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version