| Main > Main Forum |
| Ipac 4 not responding |
| (1/2) > >> |
| Willypill:
I have my cp all set up and I have the ipac 4 plugged into my ps/2. When I try to run a simple test in Notepad, I can't get a response from the Ipac 4. I press every button on my cp, but nothing works. Where should I start looking for problems? |
| Hoopz:
When you power on the pc, does the Ipac's leds light up on the pcb itself? If not, then it isnt getting power. |
| Willypill:
The lights on the IPAC 4 light up and stay lit up instantly. There is no blinking. They just come on and stay on. But no response.. |
| Hoopz:
--- Quote from: Willypill on September 24, 2005, 05:36:52 pm ---The lights on the IPAC 4 light up and stay lit up instantly. There is no blinking. They just come on and stay on. But no response.. --- End quote --- That is what they are supposed to do. So that, at least, is good. Have you used the software that came with the Ipac at all? Did you ever remove the jumper on the pcb? Make sure that is on the default setting which is Mame defaults. |
| Willypill:
--- Quote from: HooPZ on September 24, 2005, 05:52:53 pm --- --- Quote from: Willypill on September 24, 2005, 05:36:52 pm ---The lights on the IPAC 4 light up and stay lit up instantly. There is no blinking. They just come on and stay on. But no response.. --- End quote --- That is what they are supposed to do. --- End quote --- |
| Navigation |
| Message Index |
| Next page |