Main > Main Forum
How do I assemble this slot cutter?
(1/3) > >>
AceTKK:
Just got this in today from MCLS.  It's the standard 1/16" slotcutter that seems to be popular for the t-molding cuts.  Can anybody tell me how this goes together?  There were no directions included. 

Thx,

-Ace-
AceTKK:
oops, forgot to add that there's also a single nut included to hold everything together.

-Ace-
rdagger:

--- Quote from: AceTKK on September 16, 2005, 11:57:38 pm ---oops, forgot to add that there's also a single nut included to hold everything together.

--- End quote ---

On mine  you first insert a shim (washer), then the cutter, then another shim, then the bearing, then a few more shims and finally add the nut.  Make sure you put the cutter on correctly so the teeth cut with the direction the router is spinning.
alphasqorner:
Check this thread.

http://forum.arcadecontrols.com/index.php?board=1%3baction=display%3bthreadid=14402%3bstart=msg112446#msg112446
AceTKK:
Cool, thx for the info guys.  There seems to be a conflict between what's posted here and in that other thread.  Are the washers supposed to go both sides of the bearing, or on both sides of the cutter?  I'm guessing it probably doesn't make too much difference.

-Ace-
Navigation
Message Index
Next page

Go to full version