Main > Main Forum

OK to route tmolding slot while cab is upright?

Pages: << < (2/2)

jedi27:

Practice routing on some scrap wood... try routing vertically - you might do alright...

HOWEVER - I would strongly recommend you lay the cab on it's side - go for the horizontal..

Routing is also VERY dusty - especially on MDF.  Empty your cab - you don't want the dust getting everywhere - especially your trackball bearings...

Get that paint straightened out - if it's tacky now, imagine how your finish will appear with all of that sawdust on it..



Stingray:


--- Quote from: jedi27 on September 16, 2005, 12:11:11 am ---

Get that paint straightened out - if it's tacky now, imagine how your finish will appear with all of that sawdust on it..



--- End quote ---

Also a valid point.

-S

Pages: << < (2/2)

Go to full version