| Main > Main Forum |
| Bubbles in CP overlay |
| (1/2) > >> |
| bravesfan:
I installed my cp overlay over the weekend and a few days later there were some bubbles. Besides a pin-hole, are there any ways to get rid of them without removing the overlay? Just looking for more ideas |
| agfisher:
Some people use the edge of a razor blade dragged against the overlay. It is very flat and if used at the right angle and pressure will not cut. How long has the overlay been down? Adam Boston, MA |
| bravesfan:
About 2-3 days. I attached a pic. I think I must have put the controls on too fast after laying the cp overlay |
| AceTKK:
aw man, that looks pretty bad. I don't think pin holes are even going to do it; there's too much material bunched up that will never lie flat. From the looks of it your options are either to live with it or try again. -Ace- |
| ginno:
Is the trackball somehow applying pressure on the overlay to make it lift like that? I ask because you said it took a day or so to show up. |
| Navigation |
| Message Index |
| Next page |