Main > Main Forum
WARDNER I/0 ERROR
Pages: (1/1)
Apollo:
he he maybe this should be in board discussion, lol
Just bought a non-working Wardner PCB and when I switch it on I get the normal start up jumbled screen thing but then it just comes up with a black screen and the words I/0 error. I'm assuming one of the chips is bad, can anyone tell me where to go from here? Thankyou.
RayB:
Step 1 is to check to make sure none of your wires to buttons, joysticks, etc are loose, disconnected and possible touching each other causing a short.
Step 2 is to get a multimeter and measure the voltage going to your board (the +5 is the critical one).
Have you made any changes recently? Moved the cab around? Using a different extension cord? etc
Pages: (1/1)