| Main > Main Forum |
| Plans to fabricate Atari volcano buttons? |
| << < (5/15) > >> |
| paigeoliver:
I have owned plenty of these button on plenty of machines and really I can't see what the big deal about them is. I am somewhat of a purist, but I wouldn't think twice about simply drilling out a panel for a bigger button to replace them. Its not like they add ANYTHING to gameplay, or anything else. |
| JoyMonkey:
I'm going to make a test CP today; what diameter hole do the original buttons need? I'm guessing it's 3/4" |
| paigeoliver:
--- Quote from: JoyMonkey on September 15, 2005, 06:57:32 am ---I'm going to make a test CP today; what diameter hole do the original buttons need? I'm guessing it's 3/4" --- End quote --- Might want to have someone double check that number, for some reason I am thinking it is less than that. |
| Timoe:
I just want to buy a pair of buttons pre wired to simply PLUG right into my ipac and have the LEDs light when appropriate. I can then wire the switches normally. I just dont understand all the Diodes and Resistors and whatnot that I would need just to get these things to "light" off of my IPAC. |
| JoyMonkey:
--- Quote from: Ahigh on September 16, 2005, 05:52:39 pm ---Link -- - Ahigh --- End quote --- That's purdy; it would be great if that cone was the same size as the Atari cones, but they're teeny tiny I'm afraid (0.315" diameter as opposed to the 1" diameter of the Atari cone) :( |
| Navigation |
| Message Index |
| Next page |
| Previous page |