| Main > Main Forum |
| T-molding and rubber mallet |
| (1/3) > >> |
| bravesfan:
I used a rubber mallet to install my t-molding. However, the rubber mallet seemed to put some small dents in the molding. Is there any way around this? |
| versapak:
Don't pound so hard? After all... The whole point of using a rubber mallet to install the t-molding, is so that doesn't happen. |
| Minwah:
I found it quite hard to install evenly tho to be honest. It's easy to push the molding in *too* far. |
| ahofle:
Use a soft towel folded a few times where you hit. This worked really well for me and avoided the scuffs and imprints. |
| Stingray:
I always just push t-molding in by hand. I've never seen the need to use any tools for that particular job. -S |
| Navigation |
| Message Index |
| Next page |