Main > Main Forum

The new Act Labs gun

Pages: << < (5/10) > >>

bmame:

I got mine to work on an older 17 inch monitor, but cannot seem to get it to operate on the bottom third of my screen.

It works full function horizontally, but only the top 2/3 of the vertical.

The instructions say you have to hold the gun 1 inch away from the screen to calibrate; could this be my problem (I have a cabinet and can only get about 6-8 inches because of the plastic front).

Thanks.

Target:


--- Quote from: ascar9 on September 08, 2005, 02:14:09 pm ---"We are aware of the problem. The cause is the incompatibility of certain
monitors and one of the IC has to change from current ST brand to T1 brand.

--- End quote ---

i emailed them when i got the black calibration screen, havent received a response yet.
I will bother them again.

but my question is.

with me being an english speaking, non electrical engineer....

TOK:


--- Quote from: Target on September 12, 2005, 12:27:03 pm ---
--- Quote from: ascar9 on September 08, 2005, 02:14:09 pm ---"We are aware of the problem. The cause is the incompatibility of certain
monitors and one of the IC has to change from current ST brand to T1 brand.

--- End quote ---

i emailed them when i got the black calibration screen, havent received a response yet.
I will bother them again.

but my question is.

with me being an english speaking, non electrical engineer.... 

can someone translate that quote?

--- End quote ---

"We F'd up".


AC.:

Yeah, the only info I really took from that quote was:

We will send you working box then you return non working one

Target:

well; emailed support over there twice now. still no replies.

Pages: << < (5/10) > >>

Go to full version