| Main > Main Forum |
| Any way to add graphics to SlikStik? |
| (1/2) > >> |
| Skadar:
I recently ordered a SlikStik classic. As I'm sure you know, these units are finished with a black laminate. I was wondering if anybody had figured out a way to add custom graphics to the top of a SlikStik unit. I haven't really turned up anything through searches. Thanks! |
| pointdablame:
Art + plexi would probably be the easiest way, but unfortunately your T-molding will no longer cover the entire side... the height of the plexi will be above the T-molding's edge. Or just have the art printed on adhesive backed vinyl. Remove the controls, stick the art down, cut holes, replace parts..... done. You shouldn't have a problem with T-molding so much with this option since the vinyl will be relatively thin. |
| Stingray:
Vinyl would be the best option IMO. -S |
| Timoe:
Try www.mamemarquees.com for Control Panel Overlays. You might have a bump where your trackball mounting plate is or you could run the art under the mounting plate and have a big black square. |
| Skadar:
Thanks for all of the suggestions! |
| Navigation |
| Message Index |
| Next page |