Main > Main Forum
help
<< < (2/3) > >>
AceTKK:
it depends on what kind of buttons you have.  Happ buttons require a 1-1/8" hole.  Other brands are different. 
Stingray:
I used a one inch hole saw on a panel once. I was able to widen the holes with a semi-round file in a few minutes. Easier to buy the right hole saw though.

-S
ahofle:
They also make the 1 1/8" spade bits.  Check your home depot.
RayB:

--- Quote from: madhatter349 on August 12, 2005, 11:05:46 am ---i only have a 1 inch tool what should i do

--- End quote ---

--- Quote from: ultramagnus on August 12, 2005, 11:07:54 am ---yeah, or you could try "wiggling" it

--- End quote ---

Oh man, I nearly peed myself laughing.
 ;D
tommy:

--- Quote from: madhatter349 on August 12, 2005, 11:05:46 am ---i only have a 1 inch tool what should i do

--- End quote ---


--- Quote from: ultramagnus on August 12, 2005, 11:07:54 am --- try "wiggling" it

--- End quote ---

 

--- Quote from: Stingray on August 12, 2005, 12:04:29 pm --- Easier to buy the right hole


--- End quote ---
Navigation
Message Index
Next page
Previous page

Go to full version