| Main > Main Forum |
| Routed CP components. Need feedback! |
| (1/4) > >> |
| Nataq:
Any of you guys experienced any issue routing joysticks in the CP ? Im planning on using 3/4 MDF for the wood. Is it better routing the "plate" underneath the CP or above ? I guess that if its underneath we can only use small screws that wont go all the way to trough the wood not to get screws above the CP (I want a flat surface on my CP, no screws). But is that setup really solid ? Routing the CP above would be better ? Need feedback fast! Im doing the CP tomorow with one of my friend! thanx! |
| kickngas:
Rout on the top! Keep in mind the downward pressure you will be exerting on the assembly. You then run bolt and nut through and tighten for stability. Oh, I guess it depends on what joystick you use, but I used the GGG Omni-stick and routed the topside. |
| Nataq:
You did that on 3/4 wood ? |
| RaggedEdge:
I routed mine on the top last night. I like it a lot because I will get the full stick length instead of lossing 5/8" due to mounting it on the bottom. My CP is 5/8" thick. Check out my last posts to see pics. I have the Happ Super Joysticks. http://forum.arcadecontrols.com/index.php?topic=41086.0 |
| kickngas:
Yes, through the top...look at Ragged's pics. You can also see examples at Knievel's site here http://www.freewebs.com/knievel/kustomwork.htm |
| Navigation |
| Message Index |
| Next page |