Main > Main Forum
euro-stick / suzo system 500
<< < (3/7) > >>
Nataq:
Ho and those mesurements are from hole to hole right ? For the joystick placement on my CP using photoshop I would neend to know the rectangle size that I will need to route in the CP. It should be a little bigger than the hole to hole mesurement...
Level42:
I measured hole to hole, heart of the hole.

Here's some pictures, some turned out worse than I thought, but you get the idea about how the holes are I guess.

A)
The outer-most set:
7,7 cm x 6,6 cm

B)
The "middle" set:
8,0 cm x 5,0 cm

C)
The inner-most set:
8,6 cm x 4,0 cm
Level42:
NOTE: The restrictor plate on the above picture is WRONG. It is not fully turned to either side !!! Just so you know :)

Also: I mentioned the restrictor plate is of metal, not true, it's plastic (very hard and sturdy though) and the plate covering it is metal.....

Here's another pic to be complete....

Happy drilling, and no guarantee !!! I'd wait until I had the stick in my hands, but that's up to you. Maybe Andy of Ultimarc can give you a proper pdf with actual sizes ?
Grasshopper:
Here's a mounting plate diagram I did in TurboCAD.
Level42:
Zo Grasshopper=Andy ? ;D

Thanks, well I was off a mm here and there obviusly. Nataq, I'd trust that drawing of Grasshpper more thanm my measurement skills :)
Navigation
Message Index
Next page
Previous page

Go to full version