Main > Main Forum

Do J-sticks and T-sticks have identical mounting plates?

Pages: << < (2/3) > >>

Popcorrin:

I usually make a replacement plate for T-sticks that allow them to match up with the J-stick and Happ joysticks bolt pattern.  That way I don't have to worry about drilling more holes if I switch out joysticks.

Minwah:

I suppose if it came to it you could probably make a new mounting plate for the T-Stik.

AlanS17:

Well it's a non-issue now, but still an interesting topic.

I would think it would be really easy to drill new holes into the existing mounting plate. It's just a sheet of metal, right?

Minwah:


--- Quote from: AlanS17 on July 26, 2005, 04:45:51 pm ---I would think it would be really easy to drill new holes into the existing mounting plate. It's just a sheet of metal, right?

--- End quote ---

As long as it's big enough, that should be OK.  The T-Stick is thinner though so it might not be possible...I can't tell without looking at one...

AlanS17:


--- Quote from: Minwah on July 26, 2005, 05:26:59 pm ---
--- Quote from: AlanS17 on July 26, 2005, 04:45:51 pm ---I would think it would be really easy to drill new holes into the existing mounting plate. It's just a sheet of metal, right?

--- End quote ---

As long as it's big enough, that should be OK.
--- End quote ---


Pages: << < (2/3) > >>

Go to full version