| Main > Main Forum |
| Do J-sticks and T-sticks have identical mounting plates? |
| << < (2/3) > >> |
| Popcorrin:
I usually make a replacement plate for T-sticks that allow them to match up with the J-stick and Happ joysticks bolt pattern. That way I don't have to worry about drilling more holes if I switch out joysticks. |
| Minwah:
I suppose if it came to it you could probably make a new mounting plate for the T-Stik. |
| AlanS17:
Well it's a non-issue now, but still an interesting topic. I would think it would be really easy to drill new holes into the existing mounting plate. It's just a sheet of metal, right? |
| Minwah:
--- Quote from: AlanS17 on July 26, 2005, 04:45:51 pm ---I would think it would be really easy to drill new holes into the existing mounting plate. It's just a sheet of metal, right? --- End quote --- As long as it's big enough, that should be OK. The T-Stick is thinner though so it might not be possible...I can't tell without looking at one... |
| AlanS17:
--- Quote from: Minwah on July 26, 2005, 05:26:59 pm --- --- Quote from: AlanS17 on July 26, 2005, 04:45:51 pm ---I would think it would be really easy to drill new holes into the existing mounting plate. It's just a sheet of metal, right? --- End quote --- As long as it's big enough, that should be OK. --- End quote --- |
| Navigation |
| Message Index |
| Next page |
| Previous page |