| Main > Main Forum |
| Cutting a t-molding groove without a t-slot cutter. |
| << < (2/3) > >> |
| giza:
Maybe using a chisel and mallet would get the slot that you need. |
| Bones:
Solution found. A biscuit cutter. |
| CJK:
Good solution -- I was going to recommend a Japanese throwing star, but the biscuit cutter will probably work out better. 8) -- Chris |
| daywane:
those things are not cheep!!! Maybe now they are ( have not looked at them in a few years.) |
| steptoe:
if ya can get a biscuit cutter in there, why wont the router fit, ive been thinking about using a piece of stainless sheet ground to look like a router bit, should be strong enough and rip the mdf easy, make it any size you like |
| Navigation |
| Message Index |
| Next page |
| Previous page |