| Main > Main Forum |
| What to use for Trackball hole in Lexan? |
| (1/1) |
| mkdevo:
hello all, i'm at a stage where i'm working on my CP lexan. i was able to drill all the button holes fine, but now i'm at the trackball hole.. how should i go about making this hole in the lexan? router?? thanks in advance.. |
| Bones:
I used a holesaw to drill the trackball hole into the Lexan then did another hole the same size into some scrap MDF. I then put the Lexan over the MDF and lined everything up and used the bottom layer of MDF as a guide to put a nice edge on the Lexan using a router. It worked well. Check Arcade Bones in project announcements for final trackball hole finish. |
| Elfman:
I drilled a starter hole in mine and then used my router with the flush trim bit and the trackball mounting plate as my guide. Worked well in my application. |
| Taborious:
I did the same with the router and spare MDF and came out fine. I also used a bevel bit afterwards to round the whole so it was nice and smooth... |
| Navigation |
| Message Index |